Beam part #110345, 110340, or 110341.
MD Part #711B
Also fits Easyflo systems. Measures 14 inches wide by 7 inches high.
The bag has a flexible ring for support and a weight in the bottom of the bag.
Fits Beam models 167, 199, 284, 294, 289, 387, 397, 697, 2100, 2200, 2250, and 2500.
This also fits some Broan models, and the AirVac 210.
NOTE: The black rubber gasket type is no longer available.
This is a special order item. Be sure of which model you before you order.
This cloth filter bag is for the Beam central vacuum systems. It is a Gortex material as well. Also fits EasyFlo systems as well as the Nutone CV30 (CV-30) models..
Measures 11.5 inches wide by 12 inches high. Has a ring for support and a weight in the bottom of the bag. You might take the cloth bag out and and see the number 110330 imprinted on it (usually on the outside or lower, visible portion). Small Inverted Cloth Bag 110330 This is a special order item. Be sure you check the dimensions before you order. Alternative Part #: 710B
OEM Part #CVB-02-1000 2nd Stage Cloth Bag Filter for all Central Vac International brand power units. It is made of Filtrete fibers and filters out fine dust. It IS REQUIRED for the machine to operate correctly. It is also suggested by the manufacture to be replaced every 5-7 years for optimal performance. This cloth bag fits the following units: CVS-07/CVS-07DP CVS-11/CVS-11DP CVS-16/CVS-16DP CVS-19/CVS-19DP CV-07/CV-07DP CV-11/CV-11DP CV-16/CV-16DP CV-19/CV-19DP CV-150-L-10 CVS-207/CVS-207DP CVS-211/CVS-211DP CVS-216/CVS-216DP CVS-219/CVS-219DP Old Part #CV-720
Anticlogging filter and CyclofiltreTM kit for Cyclo Vac vacuum cleaners.
The anti-clogging filter is a pre-filter that catches fine dust particles and protects the CyclofiltreTM.
The CyclofiltreTM, treated with Ultra-Fresh* to prevent the growth of mold, fungus and bacteria, captures micro particles and protects the motor.
These two filters are machine washable and reusable. For E, DL and DLP series only. TTopPart
This is an inverted cloth bag for most ALL central vacuums that do not use a paper bag. It is approximately 11.5 inch wide, and has a flexible sewn-in support rim, weighted middle, and about 12 inches tall. NOTE: this will fit can with a diameter up to 14" in diameter. Also replaces cloth bag with the number 110330 imprinted on it. Gore-Tex type material. This is approximately 14 inch wide, flexible sewn-in support rim, weighted middle, and about 9 inches tall when relaxed (at lot longer when pulled). The circumference is of the outside of your vacuum unit will be about 44". NOTE: If the recces rim it snaps into is wider then 14 inches this bag will not work (some Beam and some Nutone regardless of cross references found on this site). Also replaces bag 110345, 110340, and 110341 and fits Beam 294, 289, 387, 397, 697, 2100, 2200, 2250, and 2500. To remove, grab top side and pull to center. Outer rim flexes in and the bag falls down. This fits many M&S, Filtex central vacuum systems. This is a special order item. Be sure to check the measurements before ordering.
This cloth bag fits the Silent Master, MD, Modern Day, and Flo Master units over 33-inches tall.
This will allow you to use the 721-5 paper bag. Sold individually. Diameter is 13.78
OEM Part #710
This cloth outer bag fits the MD, Modern Day, Air-Flo, and Flo Master units under 33-inches tall.
This cloth bag will allow you to use the 720-5 paper bag. Sold individually. Diameter is 13.78 inches.
Photo courtesy of Modern Day Mfg.
Copyright © 1987-2017 VACSEW.COM